Omron NX102-12 Series User Manual

Member name of RqPath data type
Variable name
MOVE
EN
IN1_8BIT
3
A . InstanceIDLogicalFormat
A . ClassIDLogicalFormat
A. ClasslD
OUT1
MOVE
EN
I
N1 OUT1
MOVE
EN
IN1 OUT1
256 A . InstancelD
MOVE
EN
IN1 OUT1
TRUE A . isAttributeID
MOVE
EN
IN1 OUT1
A . AttributeIDLogicalFormat
MOVE
EN
I
N1 OUT1
1 A . AttributelD
MOVE
EN
I
N1 OUT1
_16BIT
_8BIT
8-2-6
Service Data and Response Data
CIP communications instructions send and receive data that is stored in array variables.
Preparing Array Variables to Input and Output Service Data and Re-
sponse Data
This section describes the array variables for storing service data and response data that CIP commu-
nications instructions send and receive.

Creating Array Variables
To input a value into the array variable of a CIP communications instruction, you must create a vari-
able with the same configuration as the array variable in advance.
Example: Creating a V
ariable to Input Data to the CIPSend Instruction Array Variables
8 CIP Message Communications
8-20
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)

Omron NX102-12 Series Specifications

General

Brand	Omron
Model	NX102-12 Series
Category	Controller
Language	English