Omron NX102-12 Series User Manual

5-5
SNMP Settings Display

SNMP
Setting Description Default
SNMP service
Specify whether to use the SNMP monitor service.
*1
If the Do not use Option is selected, an SNMP manager cannot
connect from an external device.
Do not use
Port No.
*2
Set the port number to use to connect to the SNMP server that is
used to connect from an SNMP manager
.
This setting does not normally need to be changed.
161
Address Set the communications device administrator’s name and instal-
lation location as text information. Y
ou do not necessarily have to
input all items. This information is read by the SNMP manager.
(You can input up to 255 single-byte alphanumeric characters for
each item.)
None
Location None
Send a recognition
trap
Set whether to send an authentication trap.
If you select Send a recognition trap and there is access from
an SNMP manager that is not set in Recognition 1 or Recognition
2, an authentication trap is sent to the SNMP manager
.
If you select Send a recognition trap, specify the SNMP trap
settings on the SNMP Trap Tab.
Not selected
*1. If you select the Use Option for the SNMP service, you also have to set Recognition 1 and 2 as descri-
bed below
.
*2. The following ports are used by the system and cannot be set by the user: 25, 53, 68, 110, 2222, 2223,
2224, 9600, and 44818.
Additional Information
Refer to S
ection 14 SNMP Agent on page 14-1 for details on the SNMP service.
5 Sysmac Studio Settings for the Built-in EtherNet/IP Port
5-12
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)

Omron NX102-12 Series Specifications

General

Brand	Omron
Model	NX102-12 Series
Category	Controller
Language	English