1 Features and System Configuration
1-16
G5-series AC Servomotors and Servo Drives User’s Manual (with Built-in EtherCAT Communications)
1-5 Applicable Standards
This section describes applicable EMC Directives.
Note To conform to EMC Directives, the Servomotor and Servo Drive must be installed under the conditions
described in 4-3 Wiring Conforming to EMC Directives on page 4-35.
*1 Applies to 1,500-r/min Servomotors of 7.5 to 15 kW and 1,000-r/min Servomotors of 4.5 to 6 kW.
The Servo Drives and Servomotors comply with UL 508C (file No. E179149) as long as the following
installation conditions 1 and 2 are met.
(1) Use the Servo Drive in a pollution degree 1 or 2 environment as defined in IEC 60664-1 (exam-
ple: installation in an IP54 control panel).
(2) Be sure to connect a circuit breaker or fuse, which is a UL-listed product with LISTED and
mark, between the power supply and noise filter. Refer to the following table for the rated current
of the circuit breaker or fuse. Use copper wiring with a temperature rating of 75°C or higher.
1-5-1 EC Directives
EC
Directive
Product Applicable standards
Low Voltage
Directive
AC Servo Drives EN 61800-5-1
AC Servomotors EN 60034-1/-5
EMC
Directive
AC Servo Drives EN 55011 class A group 1
IEC 61800-3
EN 61000-6-2
Machinery
Directive
AC Servo Drives EN 954-1 (Category 3)
EN ISO 13849-1: 2008 (Category 3) (PLc, d)
ISO 13849-1: 2006 (Category 3) (PLc, d)
EN 61508 (SIL 2)
EN 62061 (SIL 2)
EN 61800-5-2 (STO)
IEC 61326-3-1 (SIL 2)
1-5-2 UL and cUL Standards
Standard Product Applicable standards File number
UL
standards
AC Servo Drives UL 508C E179149
AC Servomotors UL 1004-1 E331224
UL 1004-1, UL 1004-6
E331224
*1
CSA
standards
AC Servo Drives CSA 22.2 No. 14 E179149
AC Servomotors CSA 22.2 No. 100 E331224
CSA 22.2 No. 100
E331224
*1
To Next Page
Loading...
Need help?
General
