2
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
2.19
HOOD REMOVAL
IMPORTANT
The hood and side panels protect the operator from
moving parts. Never operate a snowmobile with the
side panels open or removed. Always ensure that the
hood and side panels are installed and securely latched
before starting the engine unless instructed to do so for
servicing reasons.
1. Remove the left and right side panels.
2. Rotate the 1/4 turn fasteners
q
at the rear corners of
the hood.
3. Pull hood over 1/4 turn mounts before lifting on hood.
4. Disconnect the hood wire harness connector
w
.
5. Remove the hood assembly from the vehicle.
HOOD INSTALLATION
1. Install the hood
q
by inserting the front of the hood
into the nosepan.
2. Lay the hood down onto the overstructure.
3. Reconnect the hood wire harness connector.
NOTICE
Verify the harness connectors are clean and dry prior to
assembly.
4. Secure rear of the hood to the console with the 1/4
turn fasteners.
5. Reinstall the left and right side panels.
MAINTENANCE
To Next Page
Loading...
Need help?
General
