6.36
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
4. Add DOT 4 brake fluid to proper specification
r
.
MEASUREMENT
Brake Reservoir Fluid Level:
0.1125±0.0625 in (2.856±1.588 mm)
From reservoir top
IMPORTANT
Do not overfill.
5. Reinstall gasket.
6. Install cover and fasteners. Torque fasteners to
specification.
TORQUE
Brake Reservoir Cover Fasteners:
6-8 in-lbs (0.68-0.90 N·m)
BRAKE SYSTEM BLEEDING
WARNING
Operating the vehicle with a spongy brake lever can
result in loss of brakes, which could cause an accident
and lead to serious injury or death. Never operate the
vehicle with a spongy-feeling brake lever.
CAUTION
Hot exhaust system parts can cause burns. Allow
adequate time for the exhaust system to cool. Never
perform this procedure with the engine running.
During the bleeding procedure, keep the brake reservoir
or lever as level as possible. The reservoir must be in
this position to minimize the possibility of air entering the
system through the reservoir vent.
1. Remove the three reservoir cover fasteners
q
.
2. Remove the reservoir cover
w
and gasket
e
.
FINAL DRIVE / BRAKE SYSTEMS
To Next Page
Loading...
Need help?
General
