• For details about how to make the above settings, see the manual that comes with this machine.
Checking the IP address configuration
Follow the procedure below to make sure that the IP address has been configured correctly.
•
The following procedure uses the sample IP address: 192.168.15.16.
1. Enter the following:
# ping 192.168.15.16
If the address has been configured correctly, the following message appears:
192.168.15.16 is alive
If the address has been configured incorrectly, the following message appears:
no answer from 192.168.15.16
• When you use NIS, the IP address and host name are written to /etc/hosts on the master server.
When you use DNS, the information is written to a data file on the name server. After writing the
host name and IP address to the file, make sure that the configuration is correct by pinging the host.
# ping host_name
• If the host name is registered with an IP address, the server can access the printer using its host
name instead of its IP address.
Executing the Installation Shell Script
Having configured the printer IP address, follow the procedure below to execute the installation shell
script and set up the workstation printing environment.
• Before executing the installation shell script, the IP address, host name, and printer name are
required.
•
Download the installation shell script from our Web site. Keep the installation shell script as local
folders.
The following procedures use the sample IP address: 192.168.15.16; sample host name: nphost; and
sample printer name: np.
1. Move to the directory that has the installation shell script.
2. Run the installation shell script.
# sh ./install
Using the Installation Shell Script
9
To Next Page
Loading...
Need help?
General
