Other messages
This section describes likely causes of and possible solutions for the error messages that are printed on
the error logs or reports.
Message Causes Solutions
"84: Error" There is no work area
available for image
processing.
• In [Printer Features], under
[System], set [Memory Usage] to
[Font Priority].
•
Decrease the number of files sent
to the machine.
"85: Error" The specified graphics
library is unavailable.
• In [Printer Features], under
[System], set [Memory Usage] to
[Font Priority].
•
Check that the data is valid.
"86: Error" Parameters of the control
code are invalid.
Check the print settings.
"91: Error" Printing was canceled by the
auto job cancel function due
to a command error.
Check that the data is valid.
"92: Error" Printing was canceled
because [Job Reset] or the
[Stop] key was selected on
the machine's control panel.
Perform the print operation again if
necessary.
"98: Error" The machine could not
access Hard disk correctly.
Turn off the main power switch, and
then back on again. If the message
appears frequently, contact your
service representative.
"A function which cannot be
used with Fold mode was
set. The job has been
cancelled."
A print job was cancelled
because a function(s) not
available with Fold was
selected.
Cancel the function(s) not available
with Fold. For details about the
functions not available with Fold, see
"Fold", Print
.
"Address Book is currently in
use by another function.
Authentication has failed."
The machine currently
cannot perform
authentication because the
Address Book is being used
by another function.
Wait a while, and then retry the
operation.
10. Troubleshooting
190
To Next Page
Loading...
Need help?
General
