1C-7 Engine Electrical Devices:
8) Install the upper meter panel. Refer to “Upper Meter
Panel Removal and Installation in Section 9D
(Page9D-13)”.
HO2 Sensor Inspection
B705H11306020
Inspect the HO2 sensor. Refer to “DTC “C44” (P0130,
P0135): HO2 Sensor (HO2S) Circuit Malfunction in
Section 1A (Page1A-64)”.
HO2 Sensor Removal and Installation
B705H11306021
Refer to “Heated Oxygen Sensor (HO2S) Removal and
Installation in Section 1B (Page1B-4)”.
Specifications
Service Data
B705H11307002
FI Sensors
Tightening Torque Specifications
B705H11307003
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque Specifications in Section
0C (Page0C-7)”.
Special Tools and Equipment
Special Tool
B705H11308001
Item Specification Note
ECT sensor resistance Approx. 2.58 kΩ at 20 °C (68 °F)
IAT sensor resistance Approx. 2.58 kΩ at 20 °C (68 °F)
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
ECT sensor 12 1.2 8.5 )(Page1C-3)
IAT sensor mounting screw 3.5 0.35 2.5 )(Page1C-4)
09900–25008 09900–25009
Multi-circuit tester set Needle pointed probe set
)(Page1C-3) / )(Page1C-
5)
)(Page1C-5)
09930–11950 09930–82720
Torx wrench Mode select switch
)(Page1C-6) )(Page1C-2) / )(Page1C-
6)
To Next Page
Loading...
Need help?
General
