3A-8 Drive Chain / Drive Train / Drive Shaft:
• Tighten the oil level bolt (5), oil filler bolt (6) and final
gear cover bolts (7) to the specified torque.
CAUTION
!
• Replace the gasket washer with a new one.
• Apply engine oil to each gear and bearing.
• Tighten the final gear cover bolts
diagonally.
Tightening torque
Oil level bolt (a): 16 N·m (1.6 kgf-m, 11.5 lb-ft)
Oil filler bolt (b): 23 N·m (2.3 kgf-m, 16.5 lb-ft)
Final gear cover bolt (c): 22 N·m (2.2 kgf-m, 16.0
lb-ft)
Final Drive Gear Bearing Inspection
B705H13106004
Refer to “Final Gear Disassembly and Assembly
(Page3A-4)”.
Inspect the following items.
Final gear case side
Inspect the play of the bearings by hand while they are in
the case. Rotate the inner race by hand to inspect for
abnormal noise and smooth rotation. Replace the
bearing if there is anything unusual. Refer to “Final Gear
Assembly Removal and Installation (Page3A-3)”.
Final gear cover side
Inspect the play of the bearings by hand while they are in
the cover. Rotate the inner race by hand to inspect for
abnormal noise and smooth rotation. Replace the
bearing if there is anything unusual. Refer to “Final Gear
Assembly Removal and Installation (Page3A-3)”.
(c)
7
(a)
5
(b)
6
I705H1310029-02
“A”: Play
I705H1310030-01
“A”
“A”
I705H1310036-01
I705H1310032-01
To Next Page
Loading...
Need help?
General
