2D-4 Wheels and Tires:
Front Wheel Assembly Removal and Installation
B705H12406020
Removal
1) Support the motorcycle with a jack or a wooden
block.
2) Remove the brake calipers. Refer to “Front Brake
Caliper Removal and Installation in Section 4B
(Page4B-3)”.
CAUTION
!
Do not operate the brake lever while
removing the caliper.
3) Loosen the axle pinch bolt (1) on the right front fork
leg.
4) Loosen the front axle (2).
5) Raise the front wheel off the ground and support the
motorcycle with a jack or a wooden block.
CAUTION
!
Do not carry out the work with the
motorcycle resting on the side-stand. Do not
support the motorcycle with the fuel tank and
the radiator. Make sure that the motorcycle is
supported securely.
6) Draw out the front axle and remove the front wheel.
NOTE
After removing the front wheel, install the
calipers temporarily to the original positions.
7) Remove the collar (3).
Installation
1) Install the collar (1) into the left side of the wheel.
2) Install the front wheel with the front axle.
WARNING
!
The directional arrow on the tire should point
to the wheel rotation, when remounting the
wheel.
I705H1240001-03
1
2
I705H1240002-02
3
I705H1240003-01
1
I705H1240014-01
I705H1240004-01
To Next Page
Loading...
Need help?
General
