Charging System: 1J-10
Battery Recharging
B705H11A06009
CAUTION
!
When recharging the battery, remove the
battery from the motorcycle.
NOTE
While recharging, do not remove the caps on
the top of the battery.
1) Measure the battery voltage using the multi circuit
tester.
2) If the voltage reading is less than the 12 V (DC),
recharge the battery with a battery charger.
Recharging time
0.9 A for 5 to 10 hours or 4 A for 1 hour
CAUTION
!
Be careful not to permit the charging current
to exceed 6 A at any time.
3) After recharging, wait at least 30 minutes and then
measure the battery voltage using the multi circuit
tester.
4) If the battery voltage is less than 12.5 V, recharge
the battery again.
5) If the battery voltage is still less than 12.5 V after
recharging, replace the battery with a new one.
6) When a battery is left unused for a long time, its
voltage needs to be regularly measured.
7) When the motorcycle is not used for more than one
month (especially during the winter season),
measure the battery voltage at least once a month.
Battery Removal and Installation
B705H11A06012
Removal
1) Open the front box and remove the battery cover (1).
2) Disconnect the (–) cable first, then (+) cable.
3) Take out the battery by pulling the slider (2).
Installation
Install the battery in the reverse order of removal. Pay
attention to the following point:
• Connect the (+) cable first, then (–) cable.
CAUTION
!
Never use anything except the specified
battery.
“A”: Charging period “B”: Stop charging
“A”
“B”
I649G11A0045-01
I705H11A0029-02
BATTERY
1
I705H11A0026-01
2
I705H11A0027-01
To Next Page
Loading...
Need help?
General
