Rear Suspension: 2C-10
Spacer
1) Remove the spacers from the cushion lever.
2) Inspect the spacers for any flaws or other damage. If
any defects are found, replace the spacers with the
new ones.
Cushion Lever Bearing
1) Insert the spacers into bearings.
2) Check the play by moving the spacers up and down.
If excessive play is noted, replace the bearing with a
new one. Refer to “Cushion Lever Bearing Removal
and Installation (Page2C-10)”.
Cushion Rod
Inspect the cushion rod for damage and bend. If any
defects are found, replace the cushion rod with a new
one.
Cushion Lever Bearing Removal and
Installation
B705H12306019
Removal
1) Remove the cushion lever. Refer to “Rear Shock
Absorber and Rear Shock Absorber Assembly
Removal and Installation (Page2C-4)”.
2) Remove the cushion lever bearings using the special
tools.
Special tool
(A): 09923–73210 (Bearing remover)
(B): 09930–30104 (Sliding shaft)
I705H1230009-01
I705H1230010-01
I705H1230011-01
(A)
(B)
I705H1230012-01
To Next Page
Loading...
Need help?
General
