Suzuki AN400 Service Manual

5A-6 Automatic Transmission:
5) Continue to turn the fixed drive face until it moves
simultaneously with the movable driven face in order
to have the V-belt broken in.
Drive V-belt Inspection
B705H15106003
Perform the inspection in the following procedures:
1) Remove the drive V-belt. Refer to “V-belt Type
Continuously Variable Automatic Transmission
Removal and Installation (Page5A-3)”.
2) Inspect the following items and if any defects are
found, replace the drive V-belt with a new one.
• Check for grease or oil sticking on the drive V-belt.
• Check for crack or other damage on the surface
contacted by the face.
• Measure drive V-belt width using the vernier
calipers.
Special tool
(A): 09900–20101 (Vernier calipers (1/15
mm, 150 mm))
Drive V-belt width
Standard: 25.1 mm (0.99 in)
Service limit: 24.1 mm (0.95 in)
3) After inspection, install the drive V-belt. Refer to “V-
belt Type Continuously Variable Automatic
Transmission Removal and Installation (Page5A-3)”.
Cooling Fan Filter Inspection
B705H15106004
Perform the inspection in the following procedures:
1) Remove the cooling fan duct (1).
2) Remove the cooling fan filter (2).
3) Check for dirt, clogging and damage on belt cooling
filter (2) and if any, replace the filter with a new one.
4) After inspection, install the belt cooling filter and belt
cooling duct.
I705H1510013-01
(A)
I705H1510062-01
1
I705H1510014-01
2
I705H1510015-01
2
I705H1510067-01

Suzuki AN400 Specifications

General

Brand	Suzuki
Model	AN400
Category	Scooter
Language	English