EasyManuals Logo
Home>Suzuki>Scooter>AN400

Suzuki AN400 Service Manual

Suzuki AN400
475 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
1A-7 Engine General Information and Diagnosis:
Diagnostic Information and Procedures
Engine Symptom Diagnosis
B705H11104001
“A”
“N”
“Q”
“O”
“P”
“L”
“M”
I705H1110132-01
“L”: Speedometer “O”: Ignition coil (IG Coil)
“M”: Tip-over sensor (TOS) “P”: Speed sensor
“N”: Intake air pressure sensor (IAPS) “Q”: Engine coolant temperature sensor (ECTS)
Condition Possible cause Correction / Reference Item
Engine will not start or is
hard to start
(Compression too low)
Valve clearance out of adjustment. Adjust.
Worn valve guides or poor seating of
valves.
Repair or replace.
Mistimed valves. Adjust.
Excessively worn piston rings. Replace.
Worn-down cylinder bore. Replace.
Starter motor cranks too slowly. Refer to “Starting System Diagram in Section
1I (Page1I-1)”.
Poor seating of spark plug. Retighten.
Engine will not start or is
hard to start (Plugs not
sparking)
Fouled spark plug. Clean.
Wet spark plug. Clean and dry.
Defective ignition coil. Replace.
Open or short in high-tension cord. Replace.
Defective CKP sensor. Replace.
Defective ECM. Replace.
Open-circuited wiring connections. Repair or replace.

Table of Contents

Other manuals for Suzuki AN400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki AN400 and is the answer not in the manual?

Suzuki AN400 Specifications

General IconGeneral
BrandSuzuki
ModelAN400
CategoryScooter
LanguageEnglish

Related product manuals