Suzuki AN400 Service Manual

Lighting Systems: 9B-2
Front Combination Light Removal and
Installation
B705H19206014
Removal
1) Remove the front leg shield. Refer to “Front Leg
Shield Removal and Installation in Section 9D
(Page9D-14)”.
2) Remove the front combination light.
NOTE
To facilitate the work, remove the left front
combination light first and then the right
combination light.
Installation
Install the front combination light in the reverse order of
removal. Pay attention to the following points:
• When installing, match three hooks position of the left
front combination light to each slit position of the right
front combination light.
• After installing, be sure to inspect the headlight beam.
Refer to “Headlight Beam Adjustment (Page9B-4)”.
Headlight Bulb / Turn Signal Light Bulb /
Position Light Bulb Replacement
B705H19206015
Refer to “Front Combination Light Components
(Page9B-1)”.
CAUTION
!
• A fouled glass can cause damage to the
bulb when lit. If the bulb is contacted with
bare a hand, wipe clean with a cloth
damped with alcohol or detergent.
• Do not use the bulb of a wattage other than
specification.
• As the headlight bulb operates at a high
temperature, handle the bulb after
sufficiently cooled.
Headlight Bulb
Replace the headlight bulb in the following procedures:
1) Remove the front leg shield. Refer to “Front Leg
Shield Removal and Installation in Section 9D
(Page9D-14)”.
2) Remove the covers (1).
3) Remove the springs (2) and headlight bulbs (3).
I705H1920012-01
I705H1920013-01
1
I705H1920001-01
2
3
I705H1920014-01

Suzuki AN400 Specifications

General

Brand	Suzuki
Model	AN400
Category	Scooter
Language	English