Rear Brakes: 4C-2
Rear Brake Pad Inspection
B705H14306004
The extent of brake pad wear can be checked by
observing the grooved limit line “A” on the pad. When the
wear exceeds the grooved limit line, replace the pads
with the new ones. Refer to “Rear Brake Pad
Replacement (Page4C-2)”.
CAUTION
!
Replace the brake pad as a set, otherwise
braking performance will be adversely
affected.
Rear Brake Pad Replacement
B705H14306005
Replace the rear brake pad in the following procedures:
CAUTION
!
Do not operate the brake lever and brake-lock
lever while dismounting the caliper.
Refer to “Rear Brake Components (Page4C-1)”.
1) Remove the caliper mounting bolts (1).
2) Remove the pad pins (2) and brake pads (3).
3) Clean up the caliper especially around the pistons.
4) With the caliper piston (front side) pushed back into
the caliper, force the other caliper piston (rear side)
also into the caliper by turning it clockwise.
CAUTION
!
When pushing on the caliper piston (rear
side), keep holding the caliper piston (front
side) securely to prevent it from coming out.
7. Brake-lock housing 18. Piston set : Apply thread lock to thread part.
8. Gasket 19. Dust seal : Apply brake fluid.
9. Pad spring 20. Piston seal : Do not reuse.
10. Air bleeder valve 21. Back plate
11. Boot 22. Shim
“A”
I705H1430003-03
1
I705H1430004-01
3
2
I705H1430005-01
I705H1430006-01
To Next Page
Loading...
Need help?
General
