wsm L4701 User Manual

FRONT AXLE
L3301, L3901, L4701, WSM
6-S19
(2) Disassembling Front Axle
[A] 2WD Model
Front Wheel Hub
1. Remove the cotter pin and remove the slotted nut (2).
2. Disconnect the knuckle arm (1) and tie-rod end (3).
3. Remove the front wheel cap (4).
4. Draw out the cotter pin.
5. Remove the slotted nut (5).
6. Remove the collar.
7. Remove the front wheel hub (6) with a puller.
(When reassembling)
• Replace cotter pin with a new one.
• Apply grease to the oil seal (8) in the front wheel hub.
IMPORTANT
• After tightening the slotted nut to the specified torque,
insert a cotter pin and bend it as shown in the figure.
• Pack in the grease to the bearing in the front wheel hub.
• Apply liquid gasket (Three Bond 1206C or equivalent) to the
front wheel hub.
9Y1211012FAS0025US0
Tightening torque
Front wheel hub slotted nut
29.4 to 39.2 N·m
3.0 to 4.0 kgf·m
21.7 to 28.9 lbf·ft
Tie-rod end nut
39.2 to 49.0 N·m
4.0 to 5.0 kgf·m
28.9 to 36.2 lbf·ft
(1) Knuckle Arm
(2) Tie-rod End Slotted Nut
(3) Tie-rod End
(4) Front Wheel Cap
(5) Front Wheel Hub Slotted Nut
(6) Front Wheel Hub
(7) Knuckle Shaft
(8) Oil Seal
(9) Taper Roller Bearing
(10) Taper Roller Bearing
KiSC issued 09, 2016 A

wsm L4701 Specifications

General

Brand	wsm
Model	L4701
Category	Tractor
Language	English