Service Parts Disassembly
Phaser 6600 and WorkCentre 6605Xerox Internal Use Only
Service Manual
4-2
Preface
This section contains the removal procedures for field-replaceable parts listed in the Parts List. In most
cases, the replacement procedure is simply the reverse of the removal procedure. In some instances,
additional steps are necessary and are provided for replacement of the parts. For specific assemblies
and parts, refer to Chapter 5. Parts removal and replacement procedures are divided into seventeen
categories that correspond to the parts list categories.
PL1 UI (SFP: page 5-11; MFP: page 5-12)
PL2 Laser Unit (page 5-13)
PL3 Drive (page 5-14)
PL4 NOHAD (page 5-15)
PL5 Dispenser (page 5-17)
PL6 Transfer (page 5-19)
PL7 Fuser (page 5-21)
PL8 Xerographic (page 5-22)
PL9 Tray (page 5-24)
PL10 Option Feeder (page 5-27, 5-29, 5-30)
PL13 Bypass Tray (page 5-32, 5-34, 5-36)
PL14 Duplex (page 5-38)
PL15 Registration / Feeder (page 5-39, 5-41)
PL17 Exit (page 5-43)
PL18 Electrical (SFP: page 5-45; MFP: page 5-48; Both: page 5-51)
PL19 Cover (SFP: page 5-53; MFP: page 5-56)
PL51 Scanner (page 5-60)
Notes:
• When working on an item which is controlled as a spare part but the procedure therefore
is not described, observe carefully how the part is attached before removing the item.
• As a general rule, remove optional items from the machine first, especially if they
interfere with access to a part.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
