Parts Lists
Xerox Internal Use Only Phaser 6600 and WorkCentre 6605
Service Manual
5-3
Using the Parts List
• Most of the parts lists for the MFP and SFP are common. The lists that are not common include
the product name in the title. For example, Parts List 1.1 for the SFP is titled Phaser 6600 UI
(Control Panel); Parts List 1.1 for the MFP is titled WorkCentre 6605 UI (Control Panel).
• ID No.: The callout number from the exploded part diagram.
• Name/Description: The name of the part to be ordered and the number of parts supplied per
order.
• Part Number: The material part number used to order that specific part.
• Parts identified throughout this manual are referenced PL#.#.#; For example, PL3.1.10 means the
part is item 10 of Parts List 3.1.
• A Black triangle preceding a number followed by a parenthetical statement in an illustrated parts
list means the item is a parent assembly, made up of the individual parts called out in
parentheses.
•The notation “with X~Y” following a part name indicates an assembly that is made up of
components X through Y. For example, “1 (with 2~4)” means part 1 consists of part 2, part 3, and
part 4.
•The notation “J1<>J2 and P2” is attached to a wire harness. It indicates that connector Jack 1 is
attached to one end of the wire harness and connector J2 is attached to the other end that is
plugged into P2.
• Only parts with part numbers are available for ordering. Parts without part numbers are available
on the parent assembly.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
