Section 11.0
MAN 06–0017H
ZIEHM QUANTUM User’s Manual Page 178 of 220
11.3 SHIPPING LOCKS REMOVAL
• Loosen the bolt and flip down the lever to allow the monitor arm to be rotated out
of the shipping lock. Example Fig 11.18
• Slowly rotate the monitor arm entirely out of the top portion of the Arm Support
Shipping lock. Example Fig 11.17
• Loosen the bolt and flip down the lever to allow the Arm Support Shipping lock to
be removed from the horizontal arm assembly. Exaqmple Fig 11.16
• Slowly remove the Arm Support Shipping lock from the horizontal arm assembly.
Example Fig 11.15
• Loosen the two bolts form the DeskView and lower the lever. Example Fig 11.13
• Loosen the locking bolt to secure the shipping lock. Example Fig 11.12
• While simultaneously pulling the curved portion of the bracket around the
DeskView support shaft. Pull the shipping lock forward to remove. Example Fig,
11.11
11.4 FLOOR MOUNTED REMOVAL
• Loosen the 2 bolts that secure the front wheel bracket to the floor mounting plate
and the 3 bolts that secure the left and right wheel brackets to the floor mounting
plate. Example Fig 11.9
• Remove the bracket with stencil #2 from the front wheel assembly. Example Fig
11.8
• Remove the bracket with stencil #4 from the left wheel hub assembly. Example Fig
11.7
• Remove the bracket with stencil #3 from the right wheel hub assembly. Example
Fig 11.6
• Power up the C-Arm and adjust the vertical height to 14cm. Example Fig 11.2
• Adjust the steering lever to position the steering wheels at 0 degrees to the C-Arm
body. Example Fig 11.4
• Slowly but firmly pull the C-Arm wheels down the base plate ramp while guiding
the generator assembly out of the generator cradle bracket. Example Fig 11.3
To Next Page
Loading...
Need help?
General