7. Transporting the GT-3 Series / Required Maintenance for Long-term Storage
7. Transporting the GT-3 Series / Required Maintenance
for Long-term Storage
This chapter describes the measures required before transportation, moving the printer to another location,
and the maintenance required for long-term storage.
CAUTION
Setting up and moving of the printer should only be carried out by a qualified technician.
The printer machine weighs approximately 111 kg (245 lb). Transporting and setting up of the printer
should be held in proper way.
The machine may fall down and cause injury.
Wait at least 1 minute after turning off the power switch before opening the front cover.
Do not touch the head heat sink as it may be HOT and may cause a burn.
Be careful not to get your fingers caught when closing the front cover, otherwise it may result in
injury to your fingers.
Take care not to let the liquids: Ink, Wash Liquid, Maintenance Solution, Pretreatment or waste
liquid come into contact with your eyes or onto your skin, otherwise inflammation can result. In case
of contact with eyes, do not rub but immediately rinse the eyes with water.
Furthermore, do not drink the liquids: Ink, Wash Liquid, Maintenance Solution, Pretreatment or
waste liquid under any circumstances, as they can cause vomiting and diarrhea.
Keep the liquids out of the reach of children.
7-1. Transporting the GT-3 Series
Requirements:
Prepare the following parts beforehand.
(Necessary number)
Part No. Part Name GT-341 GT-361 GT-381
SB3265 Maintenance Cartridge (Color 1 1 1
SB3264 Maintenance Cartridge W - 1 1 *
GC-50S5K Maintenance Solution (5kg) 1 1 1 *
SB2508 Filter Cartridge 4 4 4 *
SB2512 Filter Cartridge W - 2 4 *
SA5847 IH Head Case 8 12 16
SA5590 Decompress Package 4 6 8
SA5848 Cap Tube 4 6 8
SA5904 Tube Joint 1 4 6 8
SA5905 Tube Joint 2 4 6 8
SA6292 Nozzle Protect Film 4 (4 pcs) 1 2 2
SB4012 Nozzle Cover Sheet 4 (4 pcs) 1 2 2
Your customer may have the * marked parts; some packed with the printer, some consumables.
GT-3 Series
346