6-14
Printing Environment Settings
6
SETUP Menu Settings
FEEDER MENU Options
TRAY PAPER SIZE
A4*, LTR, LGL, EXEC, MIXED SIZES, CUSTOM SIZE, CUSTOM SIZE R, ENV.
ISO-C5, ENV. COM10, ENV. MONARCH, ENV. DL, ENV. ISO-B5, INDEX CARD,
STMT, 16K, A5, B5
Specifies the size of the paper loaded in the multi-purpose tray.
IMPORTANT
•
When you change the paper loaded in the multi-purpose tray frequently, it is
convenient if TRAY PAPER SIZE is set to MIXED SIZES. If TRAY PAPER SIZE is
set to MIXED SIZES, you do not need to specify the setting for TRAY PAPER SIZE
each time you load different size paper. However, when specifying MIXED SIZES,
make sure that the size of the paper loaded in the multi-purpose tray matches the
paper size specified in the printer driver before printing. If they do not match, the
printer may stop printing, displaying the message <41 CHK PAPER SZE>, or a
paper jam may occur. Be sure to check if the paper size specified in the printer
driver matches the size of the paper loaded in the multi-purpose tray before using
the printer.
•
When printing custom size paper from UFR II Printer Driver, you can load the paper
either in portrait or landscape orientation. However, if you want to print custom size
paper of its long edges 215.9 mm or less when TRAY PAPER SIZE is set to MIXED
SIZES, load the paper in landscape orientation. When you are not printing from
UFR II Printer Driver, load the paper in portrait orientation.
NOTE
•
Select CUSTOM SIZE or CUSTOM SIZE R when you want to specify custom size
paper using application and print it. If a message that prompts you to change the
size of the paper appears during printing, press the (Online) key to clear the
error before printing again.
•
You cannot print on any area within 10 mm of the edges of an envelope. (If you
have selected the [Print with Upper Left of Sheet as Starting Point] check box in
[Finishing Details] in UFR II Printer Driver, you can extend the printable area to
near the edges of the paper. For more details, see Help of UFR II Printer Driver.)
•
You can obtain the same result by specifying the setting for TRAY PAPER SIZE in
the SELECT FEEDER menu.
To Next Page
Loading...
Need help?
General