6-39
Printing Environment Settings
6
SETUP Menu Settings
SUBSTITUTE SIZE
OFF*, ON
When the paper cassette for the paper size to be used is not set in the printer, the
printer switches the paper source to the following paper cassettes and prints.
If ON is specified, the printer switches the paper size.
If OFF is specified, the printer does not switch the paper size but stops printing,
displaying an error message.
NOTE
Even if ON is specified, the printer does not switch the paper size when the paper
source for the paper size is empty.
SP.PRINT ADJ A
MODE 1*, MODE 2, MODE 3, MODE 4
Depending on the paper type or the operating environment, vertical streaks may
appear on the printed paper.
In this case, specify MODE 2 for this item.
If the problem is not solved by specifying MODE 2, specify MODE 3.
If the problem is not solved by specifying MODE 3, specify MODE 4.
IMPORTANT
•
Resetting the setting to MODE 1 due to change in paper type or operating
environment may also avoid vertical streaks appearing on the printed paper.
In this case, specify MODE 1.
•
Ver tical streaks are alleviated by specifying MODE 2, MODE 3, or MODE 4.
However, this decreases print density compared to when MODE 1 is specified.
This may also make outlines appear to be blurred or slightly jagged.
UPDATE FIRMWARE
■ USB
-
This item is to be executed only when the firmware of the printer needs to be
updated.
Printer Driver Setting Size of the Paper to Be Printed
A4 ➞ Letter
Letter ➞ A4
To Next Page
Loading...
Need help?
General