6-34
Printing Environment Settings
6
SETUP Menu Settings
■ SNMP V. 1
ON*, OFF
Specifies whether the printer should use the SNMP v. 1 protocol.
NOTE
•
For more details on SNMP v. 1, see "Chapter 2 Common Network Settings" in
Network Guide.
•
This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
■ SNMP V. 3 SET.
SNMP V. 3 ............................ OFF*, ON
USER SETTING 1 to 5*
1
AUTH .PASSWORD
ENCRYPT.PASSWRD
*
1
USER SETTING 1 to 5 is displayed only when SNMP V. 3 is set to ON.
Specify the settings related to SNMP v. 3 protocol.
If you want to specify or change user information (authentication password and
encryption password) to be used in the SNMP v. 3 protocol, perform the following
procedure.
1.
Select USER SETTING N (N = 1 to 5) using [ ] and [ ], then press [OK].
2. Confirm the user name*, then press [OK].
* "initial" (the default value) or the user name specified in the Remote UI is displayed.
3. Select AUTH .PASSWORD or ENCRYPT.PASSWRD using [ ] and [ ], then press
[OK].
4. Enter the password, then press [OK].
Input Method:
- Enter the password of 6 to 16 characters by pressing [ ] and [ ].
-Move the cursor to each field in which you want to enter a value by pressing [ ] and
[] (The cursor blinks, allowing you to enter a value.).
- If you press the (Feeder Selection) key, a space for entering a character is created
at the cursor position.
- If you press the (Cancel Job) key, the character at the cursor position is deleted.
NOTE
•
For more details on SNMP v. 3, see "Chapter3 Using the Printer on a TCP/IP
Network (Windows/UNIX)" in Network Guide.
•
This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
To Next Page
Loading...
Need help?
General