Digi XBee 3 User Manual

AT commands Network commands
Digi XBee® 3 Cellular LTE Cat 1 AT&T Smart Modem User Guide
195
Default
0xBB8 (5 minutes)
TS (IP Server Connection Timeout)
The IP server connection timeout. If no activity for this timeout then the connection is closed. When
set to 0 the connection is closed immediately after data is sent.]
Parameter Range
10 - 0xFFFF; (x 100 ms)
Default
3000
DO (Device Options)
Enables and disables special features on the XBee Smart Modem.
Bit 0 - Remote Manager support
Controls whether Remote Manager is active.
If the XBee Smart Modem cannot establish a connection with Remote Manager, it waits 30 seconds
before trying again. On each successive connection failure, the wait time doubles (60 seconds, 120,
240, and so on) up to a maximum of 1 hour. This time resets to 30 seconds once the connection to
Remote Manager succeeds or if the device is reset.
Bits 1 - 7
Reserved
Range
0-7
Bitfield
Bit Description
0 Enable Remote Manager support
1-7 Reserved for future use
Default
1 (Bit 0 enabled)

Digi XBee 3 Specifications

General

Brand	Digi
Model	XBee 3
Category	Modem
Language	English