Digi XBee 3 User Manual

AT commands BLE commands
Digi XBee® 3 Cellular LTE Cat 1 AT&T Smart Modem User Guide
231
BLE commands
The following AT commands are BLE commands.
BI (Bluetooth Identifier)
A human-friendly name for the device. This name appears in BLE advertisement messages.
If set to the default (a single ASCII space character), the Bluetooth identifier displays as the device
name, such as XBee 3 Cellular Cat 1 AT&T.
If you are using XBee Mobile, adjustments to the filter options will be needed if this value is populated.
Parameter range
A string of case-sensitive ASCII printable characters from 1 to 22 bytes in length.
Default
0x20 (an ASCII space character)
BL (Bluetooth MAC address)
The BL command reports the EUI-48 Bluetooth device address (BLEMAC address). Due to standard
XBee AT Command processing, leading zeroes are not included in the response when in command
mode.
Parameter range
N/A
Default
N/A
BT (Bluetooth enable)
The BT command enables or disables the Bluetooth functionality.
Parameter range
Bit Description
0 Bluetooth functionality is disabled.
1 Bluetooth functionality is enabled.
Default
0
$S (SRPSalt)
Note You should only use this command if you have already configured a password on the XBee device
and the salt corresponds to the password.
The SRP (Secure Remote Password) Salt is a 32-bit number used to create an encrypted password for
the XBee device. The $S command is used in conjunction with the $V, $W, $X, and $Y verifiers.

Digi XBee 3 Specifications

General

Brand	Digi
Model	XBee 3
Category	Modem
Language	English