Digi XBee 3 User Manual

AT commands Addressing commands
Digi XBee® 3 Cellular LTE Cat 1 AT&T Smart Modem User Guide
198
Default
0.0.0.0
DE (Destination port)
Sets or displays the destination IP port number used in Transparent mode.
This command reads all input as hexadecimal. All values must be entered in hexadecimal with no
leading 0x. For example, the destination port 9001 has the hexadecimal value of 0x2329. The
command would be entered as ATDE 2329.
Parameter range
0x0 - 0xFFFF
Default
0x2616
C0 (Source Port)
The IP port used to listen for incoming connections (TCP/TLS) or incoming data (UDP) when using
Transparent mode or API mode with implicit sockets.
As long as a network connection is established to this port (for TCP) data received on the serial port is
transmitted on the established network connection.
IP (IP Protocol) sets the protocol used.
For more information on using incoming connections, see Socket behavior.
Parameter range
0 - 0xFFFF
Value Description
0 Disabled
Non-0 Enabled on that port
Default
0
LA (Lookup IP Address of FQDN)
Performs a DNS lookup of the given fully qualified domain name (FQDN) and outputs its IP address.
When you issue LA in API mode, the IP address is formatted in binary four byte big-endian numeric
value. In all other cases (for example, Command mode) the format is dotted decimal notation.
Range
Valid FQDN
Default
-

Digi XBee 3 Specifications

General

Brand	Digi
Model	XBee 3
Category	Modem
Language	English