Digi XBee 3 User Manual

AT commands Addressing commands
Digi XBee® 3 Cellular LTE Cat 1 AT&T Smart Modem User Guide
197
Default
N/A
N1 (DNS Address)
Displays the IPv4 address of the primary domain name server.
Parameter Range
Read-only
Default
0.0.0.0 (waiting on cellular connection)
N2 (DNS Address)
Displays the IPv4 address of the secondary domain name server.
Parameter Range
Read-only
Default
0.0.0.0 (waiting on cellular connection)
DL (Destination Address)
The destination IPv4 address or fully qualified domain name used by Transparent mode.
To set the destination address to an IP address, the value must be a dotted quad, for example
XXX.XXX.XXX.XXX.
To set the destination address to a domain name, the value must be a legal Internet host name, for
example remotemanager.digi.com
Parameter range
0 - 128 ASCII characters
Default
0.0.0.0
The destination IPv4 address or fully qualified domain name used by Transparent mode.
OD (Operating Destination Address)
Read the destination IPv4 address currently in use by Transparent mode. The value is 0.0.0.0 if no
Transparent IP connection is active.
In API mode, the address is represented as the binary four byte big-endian numeric value representing
the IPv4 address.
In Transparent or Command mode, the address is represented as a dotted-quad string notation.
Parameter range
-

Digi XBee 3 Specifications

General

Brand	Digi
Model	XBee 3
Category	Modem
Language	English