Digi XBee 3 User Manual

AT commands BLE commands
Digi XBee® 3 Cellular LTE Cat 1 AT&T Smart Modem User Guide
232
Together, the command and the verifiers authenticate the client for the BLE API Service without
storing the XBee password on the XBee device.
The salt is configured in the $S command. In the $V, $W, $X, and $Y verifiers, you specify the 128-byte
verifier value, where each command represents 32 bytes of the total 128-byte verifier value.
Note XBee device does not allow for 0 to be valid salt. If the value is 0, SRP is disabled and you will not
be able to authenticate using Bluetooth.
Parameter range
0 - FFFFFFFF
Default
0
$V, $W, $X, $Y (SRPpassword verifier)
Note You should only use these commands if you have already configured a password on the XBee
device and the salt verifier values correspond to the password.
The $V, $W, $X, and $Y commands are used in conjunction with the $S command used to create an
encrypted password for the XBee device. Together with the $S command, these commands
authenticate the client for the BLE API Service without storing the XBee password on the XBee device.
The salt is configured in the $S command. In the $V, $W, $X, and $Y verifiers, you specify the 128-byte
verifier value, where each command represents 32 bytes of the total 128-byte verifier valule.
Parameter range
1 - 32 bytes (1-64 hexadecimal characters in command mode)
Default
0

Digi XBee 3 Specifications

General

Brand	Digi
Model	XBee 3
Category	Modem
Language	English