Test Run and Program Run | Automatic program start
18
734
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
18.6 Automatic program start
Application
Refer to your machine manual.
The control must be specially prepared by the machine
tool builder for use of the automatic program start
function.
DANGER
Caution: Danger for the operator!
The AUTOSTART function automatically starts the machining
operation. Open machines with unsecured work envelops pose a
huge danger for the machine operator.
Use the AUTOSTART function exclusively on closed machines
In a Program Run operating mode, you can use the AUTOSTART
soft key to define a specific time at which the program that is
currently active in this operating mode is to be started:
Display window for setting the starting time
Time (hrs:min:sec): Time of day at which the
program is to be started
Date (DD.MM.YYYY): Date on which the
program is to be started
To activate the start, press the OK
To Next Page
Loading...
Need help?
General
