Hitachi VSP Gx00 series User Manual

5. Close the command pr
ompt window.
Disabling TLSv1.0 and TLSv1.1 communications
To enhance security, you can disable TLSv1.0 and TLSv1.1 communications and use only
TLSv1.2.
This setting is optional.
Before you begin
You must be logged into the SVP.
Procedure
1. Close all Device Manager - Storage Navigator sessions on the SVP.
2. Open a command prompt window with administrator permissions.
3. In the folder where the tool is located, execute the following command: C:\MAPP
\wk\Supervisor\MappIniSet> tlsoff.bat.
A completion message box appears.
4. Press any key to acknowledge the message and close the message box.
5. Close the command prompt window.
6. Restart the SVP.
Enabling TLSv1.0 and TLSv1.1 communications
You can enable the disabled TLSv1.0 and TLSv1.1 communications.
This setting is optional.
Before you begin
You must be logged into the SVP.
Procedure
1. Close all Device Manager - Storage Navigator sessions on the SVP.
2. Open a command prompt window with administrator permissions.
3. In the folder where the tool is located, execute the following command: C:\MAPP
\wk\Supervisor\MappIniSet> tlson.bat.
A completion message box appears.
4. Press any key to acknowledge the message and close the message box.
5. Close the command prompt window.
6. Restart the SVP.
Blocking HTTP communication to the SVP
If the web server supports SSL (HTTPS), you can use the HTTP setting tool to block or
allow access to the HTTP communication port as needed.
Disabling TLSv1.0 and TLSv1.1 communications
Chapter 5: Setting up security
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 156

Hitachi VSP Gx00 series Specifications

General

Brand	Hitachi
Model	VSP Gx00 series
Category	Storage
Language	English