â–
The SVP is conî ´gured so that the service does not start automatically when starting
the system. See the Har
dware Reference Guide for your storage system model for
information about the SVP conî ´guration method.
Procedure
1. Copy the backup î ´le to any folder in the SVP.
2. Open a command prompt window with administrator permissions.
3. In the folder where the .bat î ´le is located, enter
C:\MAPP\wk\Supervisor\MappIniSet>MappRestore.bat absolute-path-
of-backup-file
Note:
â– The backup î ´le must be in .tgz format.
â– A space is r
equired between MappRestore.bat and the path to the
backup î ´le.
4. A completion message displays.
5. T
ype a key to close the message, and then close the command prompt.
6. Set the service to run automatically when starting the SVP.
7. Reboot the SVP. It takes about 10 minutes to complete the startup process.
Changing the administrator password
Before you begin
â–
Before changing the password of a user account speciî ´ed by the registered storage
system in the Storage Device List window, click Stop Service for the registered
storage system. After changing the password of the user account, click Edit and set
the new password, then click Start Service for the storage system.
Procedure
1. In the maintenance utility Menu navigation tree, click System Management.
2. Click Change Passwor
d.
3. Enter your current password and a new password. Enter the password again in the
Re-enter Password î ´eld.
4. Click Finish.
Changing the administrator password
Chapter 3:
Conî ´guring the storage system
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 54
To Next Page
Loading...
Need help?
General
