HP MSR SERIES User Manual

306
• They have the same region name.
• They have the same VLAN-to-instance mapping configuration.
• They have the same MSTP revision level configuration.
• They are physically linked with one another.
For example, all the devices in region A0 in Figure 314 ha
ve the same MST region configuration.
• The same region name.
• The same VLAN-to-instance mapping configuration (VLAN 1 is mapped to MSTI 1, VLAN 2 to MSTI
2, and the rest to the common and internal spanning tree (CIST or MSTI 0).
• The same MSTP revision level (not shown in the figure).
Multiple MST regions can exist in a switched network. You can assign multiple devices to the same MST
region.
VLAN-to-instance mapping table
As an attribute of an MST region, the VLAN-to-instance mapping table describes the mapping
relationships between VLANs and MSTIs. In Figure 314, f
or example, the VLAN-to-instance mapping
table of region A0 is: VLAN 1 is mapped to MSTI 1, VLAN 2 to MSTI 2, and the rest to CIST. MSTP
achieves load balancing by means of the VLAN-to-instance mapping table.
IST
An internal spanning tree (IST) is a spanning tree that runs in an MST region.
ISTs in all MST regions and the common spanning tree (CST) jointly constitute the common and internal
spanning tree (CIST) of the entire network. An IST is a section of the CIST in an MST region.
In Figure 314,
for example, the CIST has a section in each MST region, and this section is the IST in the
respective MST region.
CST
The CST is a single spanning tree that connects all MST regions in a switched network. If you regard each
MST region as a "device," the CST is a spanning tree calculated by these devices through STP or RSTP.
CSTs are indicated by red lines in Figure 314.
CIST
Jointly constituted by ISTs and the CST, the CIST is a single spanning tree that connects all devices in a
switched network.
In Figure 314, f
or example, the ISTs in all MST regions plus the inter-region CST constitute the CIST of the
entire network.
MSTI
Multiple spanning trees can be generated in an MST region through MSTP, one spanning tree being
independent of another. Each spanning tree is called a multiple spanning tree instance (MSTI).
In Figure 314, f
or example, multiple MSTIs can exist in each MST region, each MSTI corresponding to the
specified VLANs.
Regional root bridge
The root bridge of the IST or an MSTI within an MST region is the regional root bridge of the IST or the
MSTI. Based on the topology, different spanning trees in an MST region might have different regional
roots.

HP MSR SERIES Specifications

General

Brand	HP
Model	MSR SERIES
Category	Network Router
Language	English