HP MSR SERIES User Manual

498
Verifying the configuration
• After the configuration, an SNMP connection is established between the NMS and the agent. The
NMS can get and configure the values of some parameters on the agent through MIB nodes.
• Disable or enable an idle interface on the device, and the NMS receives the corresponding trap.
SNMPv3 configuration example
Network requirements
As shown in Figure 524, the NMS (1.1.1.2/24) uses SNMPv3 to monitor and manage the interface status
of the agent (1.1.1.1/24), and the agent automatically sends traps to report events to the NMS.
The NMS and the agent perform authentication when they set up an SNMP session. The authentication
algorithm is MD5 and the authentication key is authkey. The NMS and the agent also encrypt the SNMP
packets between them by using the DES algorithm and the privacy key prikey.
Figure 524 Network diagram
Configuring the SNMP agent
1. Select System Management > SNMP from the navigation tree, and then perform the following
configurations, as shown in Figure 525.
Figure 525 Configuring the SNMP agent
2. Select the Enable radio box.
3. Select the SNMPv3 radio box.
4. Type user1 in the field of Security Username.
5. Type authkey in the field of Authentication Password.

HP MSR SERIES Specifications

General

Brand	HP
Model	MSR SERIES
Category	Network Router
Language	English