HP MSR SERIES User Manual

719
Line management configuration examples
Configuring an FXO voice subscriber line
Network requirements
As shown in Figure 736, the FXO voice subscriber line connected to Router B operates in PLAR mode,
and the default remote phone number is 010-1001.
Dialing the number 0755-2003 on phone 0755-2001 connects to Router B. Because Router B operates
in private-line mode (that is, the hotline mode), it requests connection to the preset remote number
010-1001 at Router A.
Figure 736 Network diagram
Configuring Router A
# Create a call route and local number.
1. Configure a call route in the call route configuration page: The call route ID is 0755, the
destination number is 0755...., and the destination address is 2.2.2.2.
2. Create a local number in the local number configuration page: The number ID is 1001, the
number is 0101001, and the bound line is 1/0.
Configuring Router B
# Create call routes.
1. Create a call route in the call route configuration page: The call route ID is 010, the destination
number is 010….., and the destination address is 1.1.1.1.
2. Create a call route in the call route configuration page: The call route ID is 2001, the destination
number is 07552001, the call route type is Trunk, and the trunk route line is 1/0. In addition,
select the Send All Digits of a Called Number option in the Called Number Sending Mode area
when you configure the advanced settings of this call route.
# Configure the hotline number
3. Select Voice Management > Call Route from the navigation tree, and then click the icon of call
route 2001 to access the call services configuration page.

HP MSR SERIES Specifications

General

Brand	HP
Model	MSR SERIES
Category	Network Router
Language	English