HP MSR SERIES User Manual

328
• Add an account on the RADIUS server, with the username and password being hello@bbb and abc.
If the user passes authentication, it is assigned a privilege level of 3.
Figure 329 Network diagram
Configuring the RADIUS server on IMC
This example assumes that the RADIUS server runs on IMC PLAT 5.0.
1. Add the router to IMC as an access device:
a. Log in to IMC:
b. Click the Service tab.
c. Select Access Service > Service Configuration from the navigation tree.
d. Click Add.
e. Enter expert as the shared key for authentication and accounting.
f. Enter 1812 and 1813 as the ports for authentication and accounting, respectively.
g. Select Device Management Service as the service type.
h. Select HP as the access device type.
i. Select the access device from the device list, or manually add the device with the IP address of
10.1.1.2.
The IP address of the access device must be the same as the source IP address of the RADIUS
packets sent from the router. By default, the source IP address of a RADIUS packet is the IP
address of the sending interface.
j. Click OK.

HP MSR SERIES Specifications

General

Brand	HP
Model	MSR SERIES
Category	Network Router
Language	English