4
Specifying printer driver settings
4-70 bizhub C250P (Phase 3)
Center Binding
You can specify to center staple and fold a printed document.
1 Click the Layout tab.
2 From the "Center Staple and Fold" drop-down list, select "Center
Staple and Fold".
3 To avoid printing on the folded part of the document, select the "Center
Erase" check box.
2
Note
"Center Staple and Fold" cannot be specified if "Staple" or "Punch" has
been selected.
"Center Staple and Fold" is available if optional finisher FS-603 or if
saddle stitcher SD-503 is installed on optional finisher FS-514 is installed.
"Center Erase" is available only if finisher FS-603 is installed.
The available center binding and folding settings differ depending on the
finisher that is installed. When FS-514 is installed, in addition to "Fold &
Staple" (which folds the documents in half before stapling them), "Center
Staple" (which binds documents with staples at the center) and "Fold"
(which folds documents in half) are available. When FS-603 is installed,
only "Center Staple and Fold" is available.
To Next Page
Loading...
Need help?
General
