Maintenance
8
bizhub C250P (Phase 3) 8-7
Emptying the waste containers
If the hole-punch waste container in punch kit installed on finisher becomes
full, the message shown below appears (if it can be emptied by the user).
2
Note
When the message "Punch Scrap Full Call Service." appears, contact the
service representative.
The setting for the message contents for emptying the hole-punch waste
container must be specified by the service representative. For details,
contact the service representative.
!
Detail
If the hole-punch waste container becomes full, printing cannot be
performed with a Punch setting. To continue printing, empty the hole-
punch waste container or cancel the Punch setting.
To Next Page
Loading...
Need help?
General
