6
Loading copy paper
6-28 bizhub C250P (Phase 3)
6.3 Specifying finishing settings
If the optional finisher is installed, the machine can be set to finish the pages
after printing them.
The Finishing settings can be specified from the printer driver.
Stapling prints (Staple settings)
!
Detail
In order for the prints to be stapled, all of the following conditions must
be met.
The paper width must be between 182 mm and 297 mm.
The paper length must be between 182 mm and 432 mm when finisher
FS-603 is installed or between 148.5 mm and 431.8 mm when finisher
FS-514.
Prints can be fed out stapled either in the corner or at two places.
2
Reminder
Pages can be fed out stapled together only if a finisher is installed.
To Next Page
Loading...
Need help?
General
