Maintenance
8
bizhub C250P (Phase 3) 8-5
Electrostatic charger wire
If the electrostatic charger wire is dirty, streaks will appear though the printed
images. If this occurs, follow the procedure described below to clean the
electrostatic charger wire.
1 Open the machine’s front door.
2 Slowly pull out the charger-cleaning
tool as far as possible. Next, slowly
push in the charger-cleaning tool as
much as possible. Repeat the above
operations three times.
3 Securely insert each charger-cleaning tool, and then close the front
door.
To Next Page
Loading...
Need help?
General
