9: Administration
SGX 5150 IoT Device Gateway User Guide 118
To Configure Tunnel Packing Mode Settings
Using Web Manager
To configure the Packing Mode for a specific tunnel, on the Administration page, click
Tunnel > Tunnel 1 > Packing Mode.
Using the CLI
To enter the Tunnel 1 Packing command level: enable > tunnel 1 > packing
Using XML
Include in your file: <configgroup name="tunnel packing" instance="1">
Accept Mode
In Accept Mode, the SGX 5150 listens (waits) for incoming connections from the network. A
remote node on the network initiates the connection. The configurable local port is the port the
remote device connects to for this connection.There is no remote port or address. Supported serial
lines and associated local port numbers progress sequentially in matching value. For instance, the
default local port is 10001 for serial line 1 and the default local port for serial line 2 is 10002, and so
on for the number of serial lines supported. Serial data can still be received while waiting for a
network connection, keeping in mind serial data buffer limitations.
Send Character
Enter Control Characters in any of the following forms:
<control>J
0xA (hexadecimal)
\10 (decimal)
If used, the Send Character is a single printable character or a control
character that, when read on the Serial Line, forces the queued data to be
sent on the network immediately.
Note: This configuration option appears when Send Character mode is selected.
Trailing Character
Enter Control Characters in any of the following forms:
<control>J
0xA (hexadecimal)
\10 (decimal).
If used, the Trailing Character is a single printable character or a control
character that is injected into the outgoing data stream right after the Send
Character. Disable the Trailing Character by blanking the field (setting it to
<None>).
Note: This configuration option appears when Send Character mode is selected.
Tunnel Packing Mode
Settings (continued)
Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
