SGX 5150 IoT Device Gateway User Guide 71
8: Diagnostics
Diagnostic settings for the SGX 5150 unit can be viewed and modified under the Diagnostics tab in
the Web Manager user interface. This chapter describes the following diagnostic settings:
DNS
Hardware
IP Sockets
Log
Memory
Ping
Processes
Routes
Threads
Traceroute
DNS
The primary and secondary DNS addresses come from the active interface. DHCP or BOOTP can
override the static addresses from the network interface configurations.
To look up either the DNS host name or the IP address for an address, type the address or host
name in the field, then click Lookup.
This section describes the active run-time settings for the domain name system (DNS) protocol.
The primary and secondary DNS addresses come from the active interface. The static addresses
from the Network Interface configuration settings may be overridden by DHCP.
Table 8-1 DNS Settings
Accessing the DNS Settings
Using Web Manager
To view the current DNS name or IP address, on the Diagnostics page, click DNS.
To configure the DNS Settings, on the Diagnostics page, enter the name of a DNS host and
click Lookup.
Note: If DNS information is not supplied by DHCP, configure Ethernet (eth0) internet
settings according to instructions at Wired (eth0) Network (on page 44) and configure
Field/Button Description
Lookup Perform one of the following and click the Lookup button:
Enter an IP address, and perform a reverse Lookup to locate the host name for
that IP address
Enter a host name, and perform a forward Lookup to locate the corresponding
IP address.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
