9: Administration
SGX 5150 IoT Device Gateway User Guide 92
To Configure GRE Settings
Using Web Manager
To view or configure GRE settings for a specific tunnel, on the Administration page, click
GRE.
Using the CLI
To enter GRE command level: enable > gre
Using XML
Include in your file: <configgroup name=”gre”>
Host
Table 9-21 Host Settings
To Configure Host Settings
Note: The following section describes the steps to view and configure Host 1 settings;
these steps apply to other host instances of the SGX 5150 gateway.
Using Web Manager
To configure a particular Host, on the Administration page, click Host > Configuration.
Using the CLI
To enter the Host command level: enable > config > host 1
Host Settings Description
Name
Enter a name for the host. This name appears on the Login Connect Menu. To
leave a host out of the menu, leave this field blank.
Protocol
Select the protocol to use to connect to the host. Choices are:
Telnet
SSH
Note: SSH keys must be loaded or created on the SSH page for the SSH
protocol to work.
SSH Username
Appears if you selected SSH as the protocol. Enter a username to select a
preconfigured Username/Password/Key (configured on the SSH: Client Users
page), or leave it blank to be prompted for a username and password at connect
time.
Note: This configuration option is only available when SSH is selected for
Protocol.
Remote Address Enter an IP address for the host to which the SGX 5150 gateway will connect.
Remote Port Enter the port on the host to which the SGX 5150 gateway will connect.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
