Lantronix SGX 5150 User Manual

SGX 5150 IoT Device Gateway User Guide 41
TM
6: Network Settings
Network settings for the SGX 5150 can be viewed and modified under the Network tab in the Web
Manager user interface. This chapter describes the following network settings:
 Access Point
 Bridge
 Wired (eth0) Network
 Wireless (wlan0) Network
 Wired (usb0) Network
 Protocol Stack
 VPN
 Wi-Fi Protected Setup
 WLAN Scan/QuickConnect
 WLAN Profiles
Access Point
Configure software-enabled access point interface (SoftAP) on this page. Access point status
information displays at the bottom half of the page.
Table 6-1 Access Point Settings
Access Point Field Description
State Select to enable or disable the access point. If enabled, the DHCP server
will assign IP addresses to the access point clients.
Multicast Forwarding Select to enable or disable forwarding of multicast packets.
Channel Selection Select the desired channel from the drop-down menu through which the
SoftAP will operate:
 Automatic: Allow the radio to select the channel for the SoftAP.
 Configured: Specify the channel on which the SoftAP should operate.
Note: The Configured setting will only control the channel on which the
SoftAP operates as long as the station (STA) interface is not connected to
an access point. Once the STA interface has established an association
with an access point, the SoftAP will move to the STA interface's channel
(determined by the access point.) The channel selected by the user will be
validated by the UI against a list of channels supported by the radio. To
prevent inconsistent channel/band combinations the UI will coordinate the
'SoftAP channel' and 'WLAN Band' settings.
Channel Enter the Channel number to be configured.
Note: This field appears when a Configured channel selection is selected.
IP Address Enter the IP address of the SoftAP interface.
Network Name (SSID) Specify the network name/SSID of the access point. The SSID update will
take effect after the SGX 5150 gateway is rebooted.

Lantronix SGX 5150 Specifications

General

Certification	FCC ICES-003:2012 RED 2014/53/EU, EMCD 2014/30/EU, EN 300 328 V1.9.1, EN 301 489-1 V1.9.2, EN301 489-17 V2.2.1, EN 301 893 V1.8.1, EN 62311: 2008 AS/NZS CISPR 22, AS/NZS 4268: A1: 2013, AS/NZS 2772.2VCCI EN 55022:2010, EN 55024:2010, EN 61000-3-2:A2 2009, EN 61000-3-3: 2008 UL 60950/CSA 22.2 No. 60950, IEC 60950 CE LVD 2014/35/EU
LED indicators	Yes
Power requirements	9 - 30 VDC
Power over Ethernet (PoE)	No
Power consumption (typical)	1.9 W
Storage temperature (T-T)	-40 - 85 °C
Operating temperature (T-T)	-40 - 70 °C
Operating relative humidity (H-H)	5 - 95 %
Security algorithms	802.1x RADIUS, AES, EAP-FAST, EAP-PEAP, EAP-TLS, EAP-TTLS, FIPS 140-2, MSCHAPv2, TKIP, WPA, WPA2, WPA2-PSK, WPS
Authentication method	RADIUS
Ethernet LAN (RJ-45) ports	1
Supported protocols	IPv4/IPv6, TCP, UDP, ICMP, ARP, Auto-IP, DNS, (S)FTP
Frequency band	2.4 / 5 GHz
Cabling technology	10/100BASE-T(X)
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11d, IEEE 802.11g, IEEE 802.11h, IEEE 802.11i, IEEE 802.11n, IEEE 802.1x, IEEE 802.3, IEEE 802.3af, IEEE 802.3at, IEEE 802.3u
Ethernet LAN data rates	10, 100 Mbit/s

Weight and Dimensions

Weight	350 g
Dimensions (WxDxH)	110 x 89 x 26 mm