9: Administration
SGX 5150 IoT Device Gateway User Guide 126
To Configure Tunnel Modem Emulation Settings
Using Web Manager
To configure the Modem Emulation for a specific tunnel, on the Administration page, click
Tunnel > Tunnel 1 > Modem Emulation.
Using the CLI
To enter the Tunnel 1 Modem command level: enable > tunnel 1 > modem
Using XML
Include in your file: <configgroup name=”tunnel modem” instance=”1”>
USB
USB statistics can be viewed and USB settings and command mode may be configured on these
USB pages.
USB Statistics
This page displays the current status and various statistics for the USB Line.
To View USB Statistics
Using Web Manager
To view usb statistics, on the Administration page, click USB > Statistics.
Using the CLI
To enter the usb command level: enable > usb <number>
Using XML
Include in your file: <configgroup name="usb line" instance="3">
USB Configuration
This page displays the current configuration of the USB Line. Changing any of the fields takes
effect immediately. Further configuration is available at Wired Network (USB) for 'Ethernet Device'
mode.
Table 9-54 USB Configuration
USB Settings Description
Name
Enter the Name of the USB line. Named lines appear in the 'Login Connect
Menu', if enabled. Set it blank to leave it out of the menu.
Interface Select the Interface from the drop-down menu.
State Select to enable or disable the State.
Protocol Select type of Protocol from the drop-down menu: Tunnel or None.