Lantronix SLC8 User Manual

8: Device Ports
SLC™ Console Manager User Guide 109
Examples:
02_Port-2_1.log
02_Port-2_2.log
02_Port-2_3.log
02_Port-2_4.log
02_Port-2_5.log
PC Card Logging
Data can be logged to a PC card that is loaded into PC card slot on the front of the SLC unit (see
PC Cards on page 140). Data logged locally to the SLC device is limited to 256 Kbytes and may be
lost in the event of a power loss. Data logged to a PC card does not have these limitations. The
system administrator can define the file size and number of files per port. For each logging file,
once the file size reaches the maximum, a new file opens for logging. Once the number of files
reaches the maximum, the oldest file is overwritten. The file naming convention is: <Device
Port Number>_<Device Port Name>_<File number>.log.
Examples:
02_Port-2_1.log
02_Port-2_2.log
02_Port-2_3.log
02_Port-2_4.log
02_Port-2_5.log
Email/SNMP Notification
The system administrator can configure the SLC console manager to send an email alert message
indicating a particular condition detected in the device port log to the appropriate parties or an
SNMP trap to the designated NMS (see Chapter 7: Services on page 68). The email or trap is
triggered when a user-defined number of characters in the log from your server or device is
exceeded, or a specific sequence of characters is received.
Use the Device Ports - SLP / ServerTech CDU (on page 101) to set logging parameters on
individual ports.
Sylogs Logging
Data can be logged to the system log. If this feature is enabled, the data will appear in the Device
Ports log, under the Info level. The log level for the Device Ports log must be set to Info for the data
to be saved to the system log. (See Chapter 7: Services on page 68.)
To set logging parameters:
1. In the top section of the Device Port Settings page, click the Settings link in the Logging field.
The following page displays:

Lantronix SLC8 Specifications

General

Brand	Lantronix
Model	SLC8
Category	Server
Language	English