4: Quick Setup
SLC™ Console Manager User Guide 40
Date & Time Settings
Administrator Settings
6. Click the Apply button to save your entries.
Method #3 Quick Setup on the Command Line Interface
If the SLC console manager does not have an IP address, you can connect a dumb terminal or a
PC running a terminal emulation program (VT100) to access the command line interface. (See
Connecting to Terminals on page 32.) If the unit has an IP address, you can use SSH or Telnet to
connect to the SLC unit.
Note: By default, Telnet is disabled and SSH is enabled. To enable Telnet, use the
Services > SSH/Telnet/Logging page (see Chapter 7: Services on page 68), a serial
terminal connection, or an SSH connection.
IP Address
(if specifying)
Enter an IP address that is unique and valid on your network. There is no default.
Enter all IP addresses in dot-quad notation. Do not use leading zeros in the fields
for dot-quad numbers less than 100. For example, if your IP address is
172.19.201.28, do not enter 028 for the last segment.
Note: Currently, the SLC unit does not support configurations with the same IP
subnet on multiple interfaces (Ethernet or PPP).
Subnet Mask If specifying an IP address, enter the subnet mask for the network on which the SLC
console manager resides. There is no default.
Default Gateway The IP address of the router for this network. There is no default.
Hostname
The default host name is
slcXXXX, where XXXX is the last 4 characters of the
hardware address of Ethernet Port 1. There is a 64-character limit (contiguous
characters, no spaces). The host name becomes the prompt in the command line
interface.
Domain If desired, specify a domain name (for example, support.lantronix.com). The domain
name is used for host name resolution within the SLC unit. For example, if abcd is
specified for the SMTP server, and mydomain.com is specified for the domain, if
abcd cannot be resolved, the SLC device attempts to resolve abcd.mydomain.com
for the SMTP server.
Date & Time Setting Description
Change Date/Time Select the checkbox to manually enter the date and time at the SLC unit’s location.
Date From the drop-down lists, select the current month, day, and year.
Time From the drop-down lists, select the current hour and minute.
Time Zone From the drop-down list, select the appropriate time zone.
Administrator
Setting
Description
Sysadmin Password To change the password (e.g., from the default) enter a Sysadmin Password of up
to 64 characters.
Retype Password Re-enter the Sysadmin Password above in this field as a confirmation.
Network Setting Description
To Next Page
Loading...
Need help?
General