6: Basic Parameters
SLC™ Console Manager User Guide 56
DNS Servers
DHCP-Acquired DNS Servers
GPRS-Acquired DNS Servers
TCP Keepalive Parameters
3. To save your entries, click the Apply button. Apply makes the changes immediately and
saves them so they will be there when the SLC console manager is rebooted.
Ethernet Counters
The Network > Network Settings page displays statistics for each of the SLC unit's Ethernet ports
since boot-up. The system automatically updates them.
Note: For Ethernet statistics for a smaller time period, use the diag perfstat
command.
Network Commands
The following CLI commands correspond to the web page entries described above.
To configure Ethernet port 1 or 2:
set network port <1|2> <parameters>
Parameters:
mode <auto|10mbit-half|100mbit-half|
10mbit-full|100mbit-full>
state <dhcp|bootp|static|disable>
[ipaddr <IP Address> mask <Mask>]
[ipv6addr <IP v6 Address|Prefix>]
DNS Servers
#1 - #3
Configure up to three name servers. #1 is required if you choose to configure DNS
(Domain Name Server) servers.
The first three DNS servers acquired via DHCP through Eth1 and/or Eth2 display
automatically.
#1 - #3 Displays the IP address of the name servers if automatically assigned by DHCP.
#1 - #3 Displays the IP address of the name servers if automatically assigned by General
Packet Radio Service (GPRS).
Start Probes Number of seconds the SLC console manager waits after the last transmission
before sending the first probe to determine whether a TCP session is still alive. The
default is 600 seconds (10 minutes).
Number of Probes Number of probes the SLC unit sends before closing a session. The default is 5.
Interval The number of seconds the SLC device waits between probes. The default is 60
seconds.
To Next Page
Loading...
Need help?
General