SLC™ Console Manager User Guide 318
Appendix C: Safety Information
This appendix describes the safety precautions that should be followed when installing and
operating the SLC console manager. It contains the following sections:
Cover
Power Plug
Input Supply
Grounding
Fuses
Rack
Port Connections
Cover
Do not remove the cover of the chassis. There are no user-serviceable parts inside. Opening or
removing the cover may expose you to dangerous voltage that could cause fire or electric shock.
Note: Refer all servicing to Lantronix, Inc.
Power Plug
When disconnecting the power cable from the socket, pull on the plug, not the cord.
Always connect the power cord to a properly wired and grounded power source. Do not use
adapter plugs or remove the grounding prong from the cord.
Only use a power cord with a voltage and current rating greater than the voltage and current
rating marked on the unit.
Install the unit near an AC outlet that is easily accessible.
Always connect any equipment used with the product to properly wired and grounded power
sources.
To help protect the product from sudden, transient increases and decreases in electrical
power, use a surge suppressor, line conditioner, or uninterruptible power supply (UPS).
Do not connect or disconnect this product during an electrical storm.
Input Supply
This unit may have more than one power supply source. Disconnect all power supply sources
before servicing to avoid electric shock.
Check nameplate ratings to assure there is no overloading of supply circuits that could affect
over current protection and supply wiring.
To Next Page
Loading...
Need help?
General