Lantronix SLC8 User Manual

12: User Authentication
SLC™ Console Manager User Guide 197
5. Click the Apply button.
Note: You must reboot the unit before your changes will take effect.
TACACS+ Commands
These commands for the command line interface correspond to the web page entries described
above.
To configure the SLC console manager to use TACACS+ to authenticate users who log in
via the Web, SSH, Telnet, or the console port:
set tacacs+ <one or more parameters>
Parameters:
accessoutlets <Outlet List>
breakseq <1-10 Chars>
clearports <Port List>
dataports <Port List>
encrypt <enable|disable>
escapeseq <1-10 Chars>
listenports <Port List>
secret <TACACS+ Secret>
server1 <IP Address or Name>
server2 <IP Address or Name>
server3 <IP Address or Name>
state <enable|disable>
To set user group and permissions for TACACS+ users:
set tacacs+ group <default|power|admin>
To set permissions for TACACS+ users not already defined by the user rights group:
set tacacs+ permissions <Permission List>
where
<Permission List> is one or more of nt, sv, dt, lu, ra, sk, um, dp, ub,
rs, rc, dr, wb, sn, ad, po, pc
Diagnostics &
Reports
Right to obtain diagnostic information and reports about the unit.
Reboot & Shutdown Right to use the CLI or shut down the SLC console manager and then reboot it.
Firmware &
Configuration
Right to upgrade the firmware on the unit and save or restore a configuration (all
settings). Selecting this option automatically selects Reboot & Shutdown.
Device Port
Operations
Right to control device ports.
Device Port
Configuration
Right to access to port settings.
USB Right to enter modem settings for USB. The USB checkbox is available for certain
SLC and SLB models.
PC Card Right to enter modem settings for PC cards. Includes managing storage PC
cards. The PC card checkbox is available for certain SLC and SLB models.

Lantronix SLC8 Specifications

General

Brand	Lantronix
Model	SLC8
Category	Server
Language	English